Use Foil in Walls?

March 01, 2005
March/April 2005
A version of this article appears in the March/April 2005 issue of Home Energy Magazine.
Click here to read more articles about Walls

Q. I’m desperate for some balanced information. I’m putting new cement-based clapboard siding on my house on top of a plywood shell. The siding contractor said that he typically wraps the house in Tyvek. I live in the southwest corner of the Mojave Desert at about 3,200 ft above sea level and here we have both hot and cold seasons.We can go down to the teens in the winter, and at times in the summer it hits 120ºF. The climate is typically dry, but it can pour during the winter storm months. I want to do something to increase the heat-and-cool retention. I understand that Tyvek does not do this. I thought that there might be some thin insulative medium that we could apply under the painted cement siding. I researched on your Web site and found no mention of a material that I found at ( This is a reflective film to be installed in double layers and separated from the siding with a 1/4-inch gap. The site touts the improved heat-andcool retention provided by this material, which is called a radiant reflector. It is apparently not porous, and after reading some about vapor barriers on your site, I have begun to wonder about the effects of wrapping the house in this film if it needs to breathe in some way. I hope that you can offer some information that I can use to make an informed decision.

        A. Putting a vapor barrier on the outside of a structure (outside of the insulation) can be a problem when it is cold outside and significant moisture is generated inside the structure.The vapor can penetrate the structure from the inside and can condense on the insulation inside the wall. In the desert climate, moisture is less of a problem than in very cold or humid climates. Good information on vapor barriers can be found at the Building Science Corporation Web site, default.htm.
        At the Web site you mentioned, it says that climates with cold winters should not use this product on the outside of the insulation. In cooling-dominant climates with mild winters, it may be fine,depending on how cold it gets outside, how much moisture is generated inside, how well exhausted that moisture is (especially from the bathroom and kitchen areas), and in general how well ventilated the house is. The kinds of indoor finish materials and coatings that are used can also matter. If all of these were addressed so as to minimize the amount of water vapor making its way into the wall, in your climate it should be all right to use the product described on the site.The site is correct that an air space must be maintained for the radiant barrier to be effective. I assume the 1/4-inch gap between the reflective film and the siding would be provided by the use of lath or furring.
        In any case, a barrier to liquid water is needed between the siding and the structure.Tyvek works in the same manner as a number of materials that are used for breatheable but water-resistant clothing, such as GoreTex. Such materials have microscopic holes in them that allow water vapor (individual molecules of water) to pass through but that block liquid water (many molecules bound together and therefore too big to make it through the pores in the material).
        As far as resistance to conductive heat flow is concerned, you could also install rigid foam sheathing, which comes in thicknesses down to 1/4 inch. A typical 1/2-inch-thick rigid foam product provides R-3, for example. But if you have the space, a thicker product will provide more thermal resistance. Check with the manufacturer of any proposed insulation product to see if it can serve as a liquid barrier, or whether an additional barrier product is needed.

  • 1
  • NEXT
  • LAST
Click here to view this article on a single page.
© Home Energy Magazine 2023, all rights reserved. For permission to reprint, please send an e-mail to
Discuss this article in the Best Practices (Residential) group on Home Energy Pros!

Add a new article comment!

Enter your comments in the box below:

(Please note that all comments are subject to review prior to posting.)


While we will do our best to monitor all comments and blog posts for accuracy and relevancy, Home Energy is not responsible for content posted by our readers or third parties. Home Energy reserves the right to edit or remove comments or blog posts that do not meet our community guidelines.

Related Articles
SPONSORED CONTENT What is Home Performance? Learn about the largest association dedicated to home performance and weatherization contractors. Learn more! Watch Video