Insulating Closed Roof Cavities
Many homes with cathedral ceilings or flat roofs have little or no insulation. The IRC 2009 building code requires a ventilated space of at least one inch above the roof insulation. Building scientists sometimes ask how useful the ventilation is and how much ventilation could actually flow in the one-inch space.
Many cathedral roof cavities have been dense-packed with fiberglass insulation without providing space for ventilation and some experts believe this is an effective solution. However, this solution usually requires engineered plans approved by your building department.
The Best Type of Roof Insulation
The dense-packed roof cavity usually resists moisture problems because:
- Air can’t circulate through the dense-packed insulation to bring moisture or to precipitate it
- Fiberglass insulation isn’t damaged by water
- Fiberglass insulation drains water out to the lowest point
Dense-packing a roof cavity with cellulose isn’t a good option because of the high moisture absorption of cellulose.
Preparing for Roof Insulation
To prepare for roof-cavity insulation, consider these suggestions.
- In cold climates, install a vapor barrier at the ceiling. At a minimum, paint an oil-based primer over the interior drywall or plaster.
- Repair roof leaks or install a new water-tight roof. Replace moisture-damaged sheathing as part of the roof replacement.
- When replacing the roof, consider installing 2-to-12 inches of rigid, high-density foam insulation on top of the roof deck. If you choose this option, dense-pack the existing roof cavity first with fiberglass.
- Install an air-barrier ceiling (drywall) if the existing ceiling isn’t an adequate air barrier, for example: tongue-and-groove paneling.
- Remove recessed light fixtures and replace them with surface-mounted fixtures.
- Seal other air leaks with great care, especially at the perimeter and around the ridge beams.
I know of dozens of jobs where this method has been used with a higher R-value and lower cost compared to building an air space. Many roofs would have never been insulated without this allowance for the unventilated roof.
John Krigger is a passionate and respected authority on energy-efficient construction. He is also the author of several publications on the topic.
This blog orginally appeared on Saturn Resource Managment's Energy Savers Blog.
Enter your comments in the box below:
(Please note that all blog entries and comments are subject to review prior to posting.)
While we will do our best to monitor all comments and blog posts for accuracy and relevancy, Home Energy is not responsible for content posted by our readers or third parties. Home Energy reserves the right to edit or remove comments or blog posts that do not meet our community guidelines.