Cool Roofs Cool the Planet

There's an important, although little-known, advantage to cool roofs: They help cool the planet.

September 11, 2006
September/October 2006
A version of this article appears in the September/October 2006 issue of Home Energy Magazine.
SHARE
Click here to read more articles about Roof & Attic
        The Summer 2006 heat wave resulted in dramatic increases in both A/C electric bills and homeowners’ interest in cool roofs.As Home Energy readers know, cool roofs can reduce A/C use by up to 20% and improve a home’s comfort in the event of a power loss (see “Cool Colored Roofs,” HE March/April ’06, p. 12). This article focuses on a lesser known cool roof benefit— their contribution to the Earth’s albedo or reflectivity. Approaches such as cool roofs that instantly reduce global warming may well turn out to be a critical tool in countering the risk of abrupt climate change.

Albedo Basics

        Albedo—a term to make a climatologist’s heart race—characterizes how a surface reflects light (see “The Physics of Cool-Colored Roofing Materials”). We define albedo as a number between 1 and 0 that indicates the fraction of incident radiation, including the invisible ultraviolet and near-infrared parts of the spectrum, that is reflected. Planet Earth now has an average albedo of 0.3—that is, it reflects about 30% of the sunlight that lands on it (see Figure 1). There is great potential in the United States and worldwide for cool roofs. Currently more than 90% of the roofs in the United States are dark colored, with an average albedo of approximately 0.15.
         The higher albedo of a cool roof instantly reduces the amount of heat that can be trapped by the Earth’s greenhouse gases (GHGs).This instant cooling contrasts with the cooling time frame of the prevailing climate technology strategy of reducing GHG emissions.The very best that a GHG emissions reduction strategy can achieve in a human lifetime is to flatten the rate of increase in global warming, as we explain below. Since the cooling caused by an increase in land surface albedo is immediate, it is more accurate to describe it as a delay in the GHG-caused
warming than it is to describe it in terms of carbon equivalent—the more typical metric for climate technologies.

Greenhouse Gas 101

       
        To fully appreciate the difference between GHG reduction and land surface albedo strategies to counter global warming, it helps to understand how GHGs cause global warming. GHGs are almost transparent to incoming radiation, which is mostly visible and near infrared (see Figure 1). But when the Earth absorbs radiation, it reemits it at a much lower frequency—the far infrared (see the pink arrows in Figure 1). Since reflected radiation from cool roofs is still in the visible spectrum and therefore doesn’t get absorbed by GHGs, preventing the Earth’s surface from absorbing sunlight prevents a portion of the greenhouse effect from taking place.
        Increasing albedo counters humancaused (anthropogenic) global warming so much faster than GHG reduction because the root cause of GHG-induced global warming is not the gases themselves, but the radiative forcing that they cause. Forcing is defined as the amount by which the world’s thermal radiation balance—in units of watts per square meter (W/m2)—is imbalanced. Global warming is the positive forcing caused by CO2 and other GHGs. But GHGs are not the only anthropogenic form of radiative forcing. Figure 2 shows three important anthropogenic radiative forcings and the uncertainty with which they are known.Leftmost and best measured is the positive forcing due to well-mixed greenhouse gases. The middle and the right bars show the more uncertain, but negative radiative forcing due to changes in the atmospheric and land-surface albedo. For simplicity, Figure 2 does not show all forcings or the effect of ocean heat storage on radiative forcing. If these are included, the net forcing—the amount by which the Earth’s energy is imbalanced—is about 0.9 W/m2.
         The net cooling from anthropogenic land surface albedo changes is by far the smallest bar in Figure 2. It is caused by changes in land use, such as converting forest to cropland or deserts. If future human changes to the landscape— including pavement and roofs—were deliberately made with higher albedo, the potential impact would be proportionately greater. This is because the majority of the Earth’s human population now lives in cities below 45° latitude, where the direct-cooling benefits of cool roofs are the greatest.

Latitude and Solar Intensity


         Solar intensity varies with changes in latitude and the Earth’s orbit over the course of a year (see Figure 3). While atmospheric absorption, clouds, surface albedo, and mountains also affect solar intensity, latitude and orbit have a large and relatively unchanging effect. Incoming sunlight is most intense at the equator (0° latitude). Everywhere else, the incoming sunlight strikes the Earth’s surface at an angle, spreading the energy out over a larger surface area and reducing the intensity of the radiation. At the poles, averaged over the year, solar intensity is about half that at the midlatitudes. That’s why polar snowmelt—a dangerous positive albedo feedback in the Earth’s climate—has a lower-than-average impact on the Earth’s albedo, although the local effects are quite dramatic. Earth’s human population is centered at about 30° latitude, where albedo changes can have a proportionately greater-than-average impact on the Earth’s overall albedo.

The Global Benefits

        Recently Hashem Akbari and Art Rosenfeld, of the California Energy Commission,estimated the global cooling impact of cool roofs in just the largest cities (1% of land) on Earth. These urban areas consist of about 25% roof and 35% paved surfaces. Based on their experience in California,Akbari and his collaborators assume that the albedo of roofs and pavements can be cost-effectively increased by 0.25 and 0.15 respectively for a net urban area albedo change of at least 0.1.They estimated the effect of such an albedo change on global warming, using simplified climate models, published global climate model (GCM) simulations, and their own simulations. While the local cooling due to modest cost-effective changes is dramatic (approximately -5°F), the global cooling is less impressive, averaging only 0.02°F, or a three-month delay in the warming due to current world emissions. Even this small global temperature change is equivalent to a reduction in emissions of 10 billion metric tons of CO2, or a little more than one year of today’s U.S. carbon emissions.
        Robert Hamway of the Centre for Economic and Ecological Studies in Geneva, Switzerland, recently conducted another estimate of the impact of raising earth’s surface albedo. His analysis differs from that described above in that he includes all human controlled surfaces, not just those in the largest cities, and he assumes a somewhat larger albedo increase in these areas (up to a = 0.3). His very preliminary estimates are derived using a static two-dimensional model without all the features of a full-blown GCM. He estimates a globally averaged change in radiative forcing of -0.17 W/m2, or a delay of about six years in global warming. Note that the current total radiative imbalance of the Earth is approximately 0.9 W/m2, so a decrease in forcing of this magnitude would decrease the net positive forcing by nearly 20%.

What Next?

        So while cool roofs aren’t the complete solution to global warming, they can buy us critical time if we are near a threshold of an abrupt climate change. And cool roofs can save money that can be applied to other climate solutions. In California, the electricity, environmental, health, comfort, and overall energy benefits were enough to result in a code requirement for roofs. The cool roofs criteria and standards are now incorporated into the most recent California Title 24 building code. But before we encourage codes requiring high albedo for all human controlled surfaces worldwide,we need to understand their climate impact—including any potential feedbacks.
        In order to set priorities for government and other global warming policy responses,we need to do policy research on cool roof codes and other regulations versus incentives.And we need to better understand cool roof lifecycle costs and benefits, including reductions in peak electricity use, ground level ozone concentrations and related health costs, and the longer life spans of cool materials due to reduced diurnal temperature fluctuation and thus reduced expansion and contraction and degradation. For example, Rosenfeld has recently suggested setting up a fund for cool roof microloans or incentive programs in the rapidly growing megacities of the world and we are working to understand the potential cost and impact of this proposal.
        Finally, the technology research needs to continue. Now that cool roof shingles are commercially available, DOEsponsored research at Lawrence Berkeley National Laboratory and Oak Ridge National Laboratories is developing other cool materials including cooler tiles and panels and cooler paving materials.

Think Globally, Roof Locally

        Cool roofs have benefits that extend far beyond the local energy and air pollution benefits.They can also help make most homes more comfortable as the anthropogenic global warming already in the pipeline takes hold.And in addition to the direct increase in albedo, they also reduce global warming risks by reducing fossil fuel use and thus GHG emissions. Homeowners worried about climate change don’t need to wait for government action but can experience the benefits of cool roofs while reducing risk for the most vulnerable populations in developing countries and future generations. With such clear advantages and few downsides, increasing the use of cool roofs and pavements ought to be a worldwide initiative.
  • 1
  • FIRST PAGE
  • PREVIOUS PAGE
  • NEXT
  • LAST
Click here to view this article on a single page.
© Home Energy Magazine 2020, all rights reserved. For permission to reprint, please send an e-mail to contact@homeenergy.org.
Discuss this article in the Best Practices (Residential) group on Home Energy Pros!

Comments
Add a new article comment!

Enter your comments in the box below:

(Please note that all comments are subject to review prior to posting.)

 

While we will do our best to monitor all comments and blog posts for accuracy and relevancy, Home Energy is not responsible for content posted by our readers or third parties. Home Energy reserves the right to edit or remove comments or blog posts that do not meet our community guidelines.

Related Articles
SPONSORED CONTENT Insulated, Air-Sealed Drapes Learn more! Watch Video