Reducing Refrigerator Power During Peak Hours
A version of this article appears in the July/August 2008 issue of Home Energy Magazine.
July 01, 2008
Refrigerators consume about 14% of the total energy in the average U.S. household. While this may not be a very large figure, it is large enough that if most homes could cycle off their refrigerators during peak hours, we could significantly forestall the construction of new power plants. I propose a simple, low-cost modification to a standard refrigerator/ freezer unit that achieves this goal. The basic requirement is the addition of a small amount (2 gallons or so) of phase change medium near the freezer coils, and some additional control logic. Typical frost-free refrigerator/ freezer units have a single evaporator coil in the freezer section, and a small vent that allows some air to circulate between the freezer and refrigerator sections. A single thermostat controls the cycling of the system to maintain each section in the desirable temperature range. For the refrigerator section, this range is 33°F–40°F. For the freezer section, it is somewhat wider, ideally -13°F–14°F, although anything below freezing is acceptable for a short period. (The freezer temperature affects mainly the softness of any ice cream in the freezer.) Simply cutting off power to the unit during peak ...
To read complete online articles, you need to sign up for an Online Subscription.
The Home Energy Online articles are for personal use only and may not be printed for distribution. For permission to reprint, please send an e-mail to email@example.com.